|
- UHF-band PLL Synthesized design
- Frequency agility over a 25MHz bandwidth. With 48 pre-programmed frequencies available with the touch of a single button.
- Dual-antenna true diversity reception eliminating signal dropout and enhancing RF stability.
- POWER on/off and RF signal indicators.
EMR-1000
Receiver Specification Receiving Mode :
| Diversity receiving
| | T.H.D. : | 1% | Maximum S/N Ratio :
| 94 dBA | Frequency Response:
| 80Hz-15KHz ±3dB | Output Jack :
| 3.5mm stereo earphone jack
| | Output Power(32 Ω) : | 2x50mW under 1KHz(THD 3%)
| Earphone Impedance :
| ≥16Ω |
EMT-1000
Transmitter Specification Frequency Range :
| 720-865MHz
| | Bandwith : | 25MHz | | Oscillation Mode : | PLL Synthesized
| | Frequency Stability : | ±0.005% 0°C-+50°C | | Modulation Mode : | FM stereo modulation
| Maximum Deviation Range :
| ±25KHz | | T.H.D. : | <0.5% |
|
|
 - Dual 15 band 2/3 octave graphic EQ.
- Bypass switch in/out.
- High pass filter 80Hz
- XLR and TRS input and output.
|
 - Stereo dual mode operation.
- New gate timing algorithms to ensure smooth characteristics.
- Program - adaptive expander/gates.
- Accurate compression and gate theshold.
- Balance input and output on 1/4" TRS and XLR.
|
|
 - 8 Channel output, 10A per channel.
- Microkit control, Input voltage display.
- USB light connector.
|
 - 2/3/4 way electronic crossover.
- Activates 40Hz butterworth, 12dB/octave
- high pass, low pass filter
|
|
|
|
|
<< Start < Prev 1 2 Next > End >>
|
|
Page 1 of 2 |
